Setup
Unpacking
■
Remove all parts of the tripod and the operating instructions from the
packaging.
■
Remove all packing material.
Disposal of the packaging
The packaging protects the appliance from transport damage. The packaging
materials are selected from the point of view of their environmental friendliness
and disposal technology and are therefore recyclable.
The return of packaging into the material circuit saves on raw materials and
reduces the amount of generated waste. Dispose of packaging material that
is no longer needed according to the regionally established regulations.
Setting the tripod up
1)
Open the tripod out completely, so that the locking ring
column end..
2)
Turn the locking ring
longer move.
3)
Loosen the locking levers
them out to the required lengths.
4)
Align the tripod by shifting the legs as required. For this use the levelling spirit
level 6.
NOTICE
►
The air bubble must be located in the middle of the circular marking.
5)
When you have found the right position, relock the tripod legs with the
locking levers e+r.
6)
Now align - if you want to have the tripod plate
zontally - the tripod plate 3. For this, turn on the grip 0 and move it up or,
respectively, down.
NOTICE
►
The air bubble of the adjustment spirit level
the two markings.
SDS 3000 A1
w fi rmly in a clockwise direction so that it can no
e+r to unlock the legs of the tripod and pull
w touches the
3 lined up exactly hori-
4 must be located between
GB
IE
5