Installation; Hoses And Connections; Methods To Prevent Freezing - Chicago Pneumatic CP 0012 Sicherheits- Und Betriebsanleitung

CP 0012
Data plate
A. Machine type
B. Maximum permitted compressed air pressure
Serial number
C.
The warning symbol together with the book
D.
symbol means that the user must read the
safety and operating instructions before the
machine is used for the first time.
The CE symbol means that the machine is
E.
EC-approved. See the EC declaration which is
delivered with the machine for more
information. If the CE symbol is missing, it
means that the machine is not EC-approved.
Noise level label
The label indicates the guaranteed noise level
corresponding to EC-directive 2000/14/EC. See
"Technical data" for accurate noise level.
Safety label
To avoid injury, before using or servicing tool, read
and understand separately provided safety
instructions.
9800 0548 90a | Original instructions
www.CrowderSupply.com • Toll Free: 888-883-5144
Safety and operating instructions

Installation

Hoses and connections

Compressed air source
A.
Water separator (optional)
B.
C. Oiler (optional)
D. Max. 10 feet (3 meter) compressed air hose
between the oiler and the machine.
Check that you are using the correct
♦
recommended operating pressure, 87 psig (6 bar
(e)).
The maximum permissible air pressure, 90 psig
♦
(6.2 bar (e)), must not be exceeded.
Blow any impurities out of the compressed air
♦
hose before connecting it to the machine.
Select the correct dimension and length for the
♦
compressed air hose. For hose lengths up to 100
feet (30 meters), a hose with a minimum internal
diameter of 3 ⁄ " (19 mm) should be used. If the
4
hose length is between 100 and 330 feet (30 and
100 meters), a hose with a minimum internal
diameter of 1" (25 mm) should be used.

Methods to prevent freezing

Ice formation in the muffler can occur when the
ambient air temperature is 32-50 °F (0-10 °C) and
the relative humidity is high.
The machine is designed to avoid the formation of
ice in the muffler. Despite this, under extreme
conditions ice can form in the muffler.
The following actions can be taken to further
counteract the risk of ice formation:
Use an air tool oil containing antifreeze agents.
♦
Use a water separator.
♦
13