pixima fontanot MINI LINE Montageanleitung Seite 6

using article C64 and glue X01 (fig. 1).
18. I nsert the steel cables F26 (fig. 7) into articles D39 found on the balusters. Secure the cables to
one of the ends using articles D4 and C76, leaving an extra 5 mm of cable protruding from article
D40. Tighten the cables by hand and secure using articles D40 and C76. Cut the cables at a
distance of 5 mm from article D40. Secure articles D38 to protect the cables with articles C76.
Warning: when cutting the cables, we recommend winding the part in question with adhesive tape
to avoid fraying and using a suitable shearer.
Final Assembly
19. C heck the verticality of the entire staircase and - if necessary - correct by moving support N16
(fig. 1).
20. D ismantle the first tread (L19 or L20) and drill the floor using a Ø 14 mm point in the same place
as the openings found on support N16 (fig. 1).
21. Insert elements C39 and secure in a permanent manner (fig. 1).
22. Remount the first tread (L19 or L20).
23. Insert articles C74 into balusters C67 to complete staircase assembly (fig. 1).
After you have finished assembling the staircase,
please visit our website and send us your suggestions: www.pixima.it
7 - MINI LINE