Maintenance; Troubleshooting - Parrot BD1725 Montageanleitung

INSTALLATION (Continued)
1 2 3
A
5
Mounting Glass Pentray:
1. Mark two positions on the wall for drilling that are 200mm apart.
2. Drill an 8mm hole on the marked areas from the previous step.
3. Place the two plastic wall plugs into the holes you have just drilled.
4. Insert the masonry screw into the mounting bracket until the tip of the screw is sticking through the
end of the standoff.
5. Place the mounting bracket on the wall so that the screw tip inserted into the plastic wall plug and
screw securely in place.
6. Place the pen tray into the slot in the mounting bracket & place the set screw in position below the slot
and fasten the screw securely to hold the pen tray safely in place.
3
4
1
Glass Pentray
2
Glass Mounting Bracket
3
8mm Hole
4
Set Screw
5
Plastic Wall Plug
6
Masonry Screw
6

MAINTENANCE

1. Use a non-abrasive cloth or whiteboard eraser to clean the surface.
2. Use Office Equipment & Whiteboard Cleaner (Re-Order Code: BA0201) for the
best all-round protection and surface cleaning.
3. Do not use abrasive detergents on the surface as this will affect your warranty.
4. Do not leave permanent marker on the surface for extended periods of time.

TROUBLESHOOTING

1. For stubborn marks and permanent marker use
Cleaner (Re-Order Code: BA0201) to remove the permanent marker from the surface.
CAUTIONS & WARNINGS
This board is not intended for use on dry-walls.
Choking hazard - This product contains small parts.
This board is a non-toxic product.
The contents of this package contain fragile parts. Special care should be taken when
handling this package and removing it's contents to avoid damage or breakage to the product.
Office Equipment & Whiteboard
4