Installation - Parrot BD1725 Montageanleitung

CONTENTS
1 2 3
1
4 x Stainless Steel Standoffs
2 1 x 4mm Magnetic Glass Whiteboard
3
1 x Glass Pentray
4
2 x Stainless Steel Mounting Brackets For Pentray
5
4 x 30mm Extra Strength Magnets (Re-Order Code: BA0609)
6
1 x Whiteboard Eraser (Re-Order Code: BA0102)
7
2 x Whiteboard Markers (Re-Order Code: PW0401A - Marker Whiteboard Bullet Carded 4)
1
4 5 6 7

INSTALLATION

CAUTION! To prevent possible breakage or chipping make sure the
corner protectors are in place during installation
A
1.
2.
3.
4.
5.
6.
Mounting Glass Board:
Position board onto the wall using mounting holes
as a template for drilling to ensure correct
placement.
Remove the board from the wall & drill an 8mm
hole on the marked areas from the previous step.
Place the four plastic wall plugs into the drilled
holes.
Insert the masonry screws into the standoffs until
the tip of the screw is sticking through the end of
the standoff.
Place the standoffs on the wall so that the screw
tip is inserted into the plastic wall plug & screw
securely in place.
With a second person holding the glass board in
place, fasten the standoff caps securely in place.
Make sure that there is a plastic washer on either
side of the glass board for protection around the
screwing area.
1
Standoff Cap
2
Plastic Corner Protector
3
Standoff Body
4
8mm Hole
5
Plastic Washer
6
Masonry Screw
7
Plastic Wall Plug
2