Installation Of 7 Day Timer - Toshiba RBC-WT1-PE Installationsanleitung

7Day Timer Instal 1401449601R01
I
NSTALLATION OF
CAUTION
Low voltage circuitry is used for the 7 Day Timer, the cable is subject to the low-power circuit
provision of internal wiring regulations and therefore it cannot be brought into direct contact with a
high-voltage AC power line, or housed in the same conduit tube as a power line.
HEAT PUMP AI MODELS
Flush Wall Mounting
The maximum extended length of the 7 Day Timer cable which can be used is 10 metres.
Install the 7 Day Timer where it can be easily operated.
The decorative cover can be removed by prising the section indicated by the arrow, using an
ordinary flat screwdriver.
The in-built memory backup capacitor will prevent memory loss during power failure.
To set up the 7 Day Timer please refer to the operating instructions in the 7 Day Timer
OwnerÕs Manual.
3-core PVC cable, obtained locally
Wall Surface Mounting
Make a U-shaped cut-out in the centre of the top edge of the decorative cover and pass the 3-
core PVC round cable through the cut-out.
Cutout
9/12/99 12:23 pm
GB
7 D T
AY IMER
7 D T
AY IMER
Use parts which conform with
the relevent electrical standards.
Obtain the conduit tubes,
bushings and lock nuts locally.
Mounting screws (x2) obtained locally
Mounting screws (x2) obtained locally
– 4 –
Page 4