Before First Use - Petra electric puretea IK 10.00 Bedienungsanleitung

Instruction manual

BEFORE FIRST USE

Start
• Remove stickers, if any, from the base or the glass jar except for the
stickers at the bottom of the base.
• Place the base on a dry, flat and stable surface.
• Do not wind the cord round the reel in the base.
• Rinse the glass jar with water.
• Fill the water & tea cooker with water up to the maximum level and let
the water boil once. See chapter 'USING THE APPLIANCE'.
• Pour out the hot water and repeat that process once more.
• After that, the water & tea cooker is ready to use.
USING THE WATER & TEA COOKER (FIGURE 2.)
Put the plug into the wall socket.
Fill water & tea cooker with water through lid
To fill the water & tea cooker with water, you first have to open the inner lid
by turning it anti clockwise. You can also remove the inner lid or the whole
lid but this is not necessary.
IMPORTANT (Figure 3.):
• Always fill the water & tea cooker between the 0.3L minimum (MIN) and
1.5L maximum (MAX) marks on the water gauge.
• Too little water will result in the water & tea cooker switching OFF before
the water has boiled. Filling above maximum (MAX) mark may result in
boiling water splashing from the water & tea cooker.
Fill with the desired amount of water.
6
IMPORTANT:
• The energy consumption of the appliances can be optimized by heating
only as much water as is actually needed.
• Close the lid before you switch on the water & tea cooker.
360° Positioning on base (Figure 4.)
Designed to allow you to place the glass jar on the base in any direction.
Convenient for both left and right handed users.
BUTTON FUNCTIONS
Power on / off indication and activation button