Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
A system with the CT-824S can operate even if there is a mains power outage by installing two 12V
2.2Ah batteries (not supplied) without making any change to the system.
Connection sequence:
•
Disconnect the 230Vac power supply
•
Connect the two batteries in sequence paying attention to the terminal polarity No.33 BAT+
and No. 34 BAT-
•
Check that the safety LED's come on
•
Re-connect the mains power supply
•
New batteries charge up after about ten hours.
The number of manoeuvres that can be performed with the battery supply depends on many fac-
tors; an approximate example could be 4 complete cycles under the following conditions:
•
hinged doors 3 mt 250 kg
•
system with 1 pair of photocells, snap-in receiver and 1 flasher (20W max.)
•
batteries charged
•
within 5 hours of 230V power supply failure
•
The installation of the automation must be performed properly by qualified personnel in pos-
session of legal requirements and in compliance with machine directive.
•
Check the solidity of existing structures (columns, hinges, doors) in relation to the force gen-
erated by the motor.
•
Check that there are suitably sturdy mechanical stops at the end of opening and closing
travel of the doors.
•
Analyze the risks of the automation and adopt necessary safety measures and warnings.
•
install controls (such as the key selector) so that the user is not in a hazardous position.
•
Upon completion of installation, check the safety devices several times, as well as those for
signalling and automation release.
•
Provide the automation with the EC label or tag that contains the danger information and
identification data.
•
Give the final user the instructions for use, safety warnings and the EC declaration of con-
formity.
•
Make sure the user understands proper automatic, manual and emergency operation of the
automation.
•
Inform the user in writing (for example in the instructions for use) of any unprotected residual
risks and foreseeable improper use.
•
Provide a maintenance schedule for the system (at least every 6 months for the safeties)
with an appropriate register of work performed.
•
Keep this instruction manual for future reference.
•
Key Automation S.p.A. reserves the right to make, at any time, any modifications which may
be required to improve appearance and/or operation.
This product is composed of various components which may in turn contain pollutants.
Do not dispose of it in the environment! Find out about the method for recycling or dis-
posing of the product in compliance with current local laws
BATTERY KIT
FINAL WARNINGS
DISPOSAL
20
Werbung
Inhaltsverzeichnis
