Technical Data; Maintenance - Ritter 93208 Bedienungsanleitung

TEcHnIcAL DATA

• Voltage:
• Type:
• Illuminant:
• Luminous flux:
• Colour temperature:
• Protection class:
InSTALLInG THE HAnDLE AnD BASE (see 1)
• Loosen the wing nut on the support and insert the base into the handle.
Insert the wing nut into the hole provided on the handle and tighten it.
SETTInG THE FLooDLIGHT DIREcTIon
• Loosen the screws on the sides underneath the housing and adjust the
floodlight direction – ensure that the handle is not illuminated – and then
retighten all screws.
InSTALLInG THE TRIPoD
Tripod legs by pushing down the guide collar Fold (b). For height adjustment
loosen the locking screw (a), stand off to the desired height and lock them
again. (p.2) Attach the floodlight using the supplied screw in the center hole
of the housing bracket to the stand. (p.2)
cLEAnInG
• Before cleaning the LED floodlight, disconnect the power cable and allow
the floodlight to cool down sufficiently.
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent
if required. Do not use cleaners that contain abrasives or solvents.

MAInTEnAncE

• Check the plug, power cable, and housing of the LED floodlight for damage
before each use. If the lens is damaged it must be replaced immediately.
• Clean any dirt from the housing or the lens immediately, since it could
cause overheating.
230V~, 50Hz
93208, 932085
LED 12 x 1W
approx. 860lm
6400K
IP44
GB
7