Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Machine Speci c Safety Instructions
Know your hammer drill. Do not plug in the hammer drill until you have read and understand this Instruction Manual. Learn the
tool's applications and limitations, as well as the specific potential hazards related to this tool.
• Remove all packaging materials and the transport safeguards, if present. Keep packaging materials away from children –
danger of suffocation!
• Use only hammer drill bits and accessories that are designed for use with a hammer drill when using this hammer drill in the
hammer mode. Standard drill bits are NOT designed for use in a hammer drill and MUST NOT be used with a hammer drill.
They may shatter and possibly cause serious injury.
• Always keep hands out of the path of the drill bit. Avoid awkward hand positions where a sudden slip could cause your hand
to move into the path of the drill bit.
• When drilling walls ensure that there are no concealed electrical cables.
• To avoid injury from accidental starting, always remove the plug from the power source before installing or removing a drill
bit.
• Before starting the operation, press the drill switch to make sure the drill bit does not wobble or vibrate.
• Make sure the spindle has come to a complete stop before touching the chuck or attempting to change the drill bit.
• Always make sure the chuck is tight and the drill bit firmly tightened in the chuck before starting drill.
Operating Instructions
9
1
Forward/Reverse Switch (1) (Fig. 1)
To make the drill rotate clockwise for drilling, push the forward/re-
verse switch to the left. To make the drill rotate counter-clockwise,
push the forward/reverse switch to the right. Never change the
position of the forward/reverse switch while the chuck is turning.
Variable-Speed Trigger Switch (2) (Fig. 1)
This drill is equipped with a variable-speed ON/OFF trigger switch.
• To start drill, gently squeeze the trigger switch.
• The drill will turn at its slowest speed when the trigger switch is depressed slightly. The drill will turn at its fastest speed when
the trigger switch is fully depressed.
• To stop the drill, release the trigger switch.
• Drilling at a slow speed for an extended period of time may cause the drill motor to overheat. If drill gets hot, stop drilling and
allow it to cool for at least 15 minutes.
4
8
2
3
7
1. Chuck
2. Forward/reverse switch
5
3. Variable speed trigger switch
4. Auxiliary handle
5. Air vents
6. Lock-on button
6
7. Chuck key
8. Drill/hammer mode switch
9. Depth stop rod
Fig. 1
Werbung
