Specifications - Hitachi S 18SB Bedienungsanleitung

d) Use special care when working corners, sharp edges
etc. Avoid bouncing and snagging the accessory.
Corners, sharp edges or bouncing have a tendency
to snag the rotating accessory and cause loss of
control or kickback.
e) Do not attach a saw chain woodcarving blade or
toothed saw blade.
Such blades create frequent kickback and loss of
control.
SAFETY WARNINGS SPECIFIC FOR SANDING
OPERATIONS
a) Do not use excessively oversized sanding disc paper.
Follow manufacturers recommendations, when
selecting sanding paper.
Larger sanding paper extending beyond the sanding
pad presents a laceration hazard and may cause
snagging, tearing of the disc or kickback.

SPECIFICATIONS

Voltage (by areas)*
Power Input*
No-load speed
Weight (only main body)
*Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) 180mm Sanding Disc (Grain size: P50 or P16) ......... 1
(2) Rubber Pad ................................................................. 1
(3) Wrench ........................................................................ 1
(4) Side handle ................................................................. 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
(1) 180mm Sanding disc
There are eleven different kinds of sanding disc,
having grain sizes of P16, P20, P24, P30, P36, P40,
P50, P60, P80, P100, P120. When placing your order,
please specify the grain size of the disc desired.
Optional accessories are subject to change without notice.
APPLICATIONS
Sanding metal surfaces.
Preliminary sanding of metal surfaces before
painting, rust removal, removing old paint before
repainting.
Finishing woodwork, correcting projections of
timbers from joints or assemblies.
Preliminary sanding of wood surfaces before
applying paint.
PRECAUTIONS ON USING DISC SANDER
1. Keep away from a revolving sanding disc.
2. Pay strict attention to sparks.
3. Hold the disc sander firmly.
4. Do not leave the revolving disc sander unattended
on the floor.
5. Be careful those around one while operating.
6. Follow the procedures of these handling
instructions on sanding disc replacement.
7. Never mount a depressed center wheel on this
tool and attempt to use it as a disc grinder.
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
4500 min
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
CAUTION:
Damaged cord must be replaced or repaired.
4. Attaching sanding disc
For attachment/removal of the sanding disc, refer
to "ATTACHMENT/REMOVAL OF SANDING DISC".
Many types of sanding discs are available; select
one appropriate to the work.
5. Fixing the side handle
Screw the side handle into the housing.
6. Confirm the lock lever.
Confirm that the lock lever is disengaged by pushing
lock lever two or three times before switching the
power tool on (See Fig. 2).
English
705 W
–1
2.0 kg
6