Lampagnolo ErgoBrain Installationsanleitung Seite 8

SPD
Within 10 cm
CDC
SPD Sensor and Magnet / CDC Sensor and Magnet
• Install the sensors so that the clearance between the sensors and their
magnets become less than 5mm, and that the center of the magnets and
their sensors' marking lines align when rotating the wheel.
Important: attach the sensor and the magnet within 10cm from the hub axle.
Attach the SPD sensor to the right front fork. Attach the SPD magnet to the
spoke of the front wheel.
Attach the CDC sensor to the left chainstay. Insert the CDC magnet into the hole
of the pedal axle. If this is not possible, install the covered magnet on the inner
side of the crankarm using the nylon tie supplied.
Note: Magnets can damage watches and other instruments.
Note: Fix the sensors and magnets securely so that they will not become loose
when riding.
SENSOR
5 mm
5 mm
- 4
UK