Audio Pro ALLROOM AIR ONE Bedienungsanleitung Seite 6

ECO MODE OR SLEEP MODE
Eco-mode is the Allroom Air One factory default setting. Using this setting saves power.
When you stop playing music, the Air One will go into a low-power state after 30 minutes.
Once the Air One has gone into this low-power state, it will not wake up automatically when
you begin playing music and will not show up as an available wireless network. Use the
On/Standby button on the remote to bring the Air One back to full-on state and ready to
play again.
Eco-mode can be disabled if you want the Air One to start automatically and stay visible on
E C O
your list of available networks. This setting uses more power.
To switch between Eco-mode and Sleep mode operation settings, press at the same time the
S L P
two buttons marked AIR PAIR and VOL–, holding the press for 3 seconds. The display will
show the symbols SLP or ECO corresponding to your selection.
AIRPLAY WIRELESS SETUP
Before playing music on your Allroom Air One loudspeaker, you need to connect it to a wireless network.
There are four easy ways to connect the Allroom Air One to your wireless home network.
1. SETUP WITH ROUTER WITH WPS BUTTON
Check if your router has a WPS button. Press button and
WPS LED will start flashing. Then press the AIR PAIR button
on Allroom Air One, LED will flash red-purple-blue. If wire-
less signal is strong enough, Allroom Air One automatically
connects to your wireless network, and LED will be solid
blue. You are now ready to play your music wirelessly.
LED flashes slow blue if the connection failed.
2. SHARE YOUR IOS DEVICE'S WIFI SETTINGS
See instructions below.
2. QUICK WIRELESS SETUP - SHARE YOUR IOS DEVICE'S WIFI SETTINGS
1. Make sure your iOS device is
connected to your home wifi network.
Plug your iOS device into the USB port
with your power cable.
6
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including interference
that may cause undesired operation.
XCO-AIRONE
7765A-AIRONE
2.Press the Air Pair button on the
speaker til LED flashes blue/purple.
3. Dialogue window appears on your
iOS device. Press "Allow". Done!
The speaker will now restart, wait until
the LED shows steady blue light.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including interference
that may cause undesired operation.
XCO-AIRONE
7765A-AIRONE
3. SETUP WITH THE AUDIO PRO APP
Download the free Audio Pro AirPlay setup app from Apple
App Store, and follow instructions in the app. Search for
"Audio Pro AIR" on App Store.
4. SETUP USING YOUR INTERNET BROWSER
See instructions below. (If you use Android/Windows Phone
device, this setup is the one you should use.)
To play your music: Find the AirPlay
logo in your music service to choose
the speaker. The speaker will be
named: AudioPro_AA1_12345
Share Wi-Fi Settings?
Do you want to share your Wi-Fi
settings so this accessory can
connect to the Wi-Fi network?
Ignore Allow