Draining The Appliance; Appliance Handover - Stiebel Elron SBP 200 E Bedienung Und Installation

INSTALLATION
Commissioning
9. Commissioning
Material losses
!
If a threaded immersion heater has been installed, the
maximum temperature of the DHW cylinder may need to
be limited. This prevents the temperature limiters of the
installed accessories from responding.
Material losses
!
A safety valve is required.
f Fill and vent the appliance. f
f Fit and check accessories as required. f
9.1 Oxygen diffusion
Material losses
!
Avoid open vented heating systems and underfloor heat-
ing systems with plastic pipes which are permeable to
oxygen.
In underfloor heating systems with plastic pipes that are per-
meable to oxygen and in open vented heating systems, oxygen
diffusion may lead to corrosion on the steel components of the
heating system (e.g. on the indirect coil of the DHW cylinder, on
buffer cylinders, steel radiators or steel pipes).
Material losses
!
The products of corrosion (e.g. rusty sludge) can set-
tle in the heating system components, which may re-
sult in a lower output or fault shutdowns due to reduced
cross-sections.
Material losses
!
Avoid open vented solar thermal systems and plastic
pipes which are permeable to oxygen.
With plastic pipes that are permeable to oxygen, oxygen diffusion
can cause corrosion on the steel components of the solar thermal
system (e.g. on the indirect coil of the DHW cylinder).
9.2 Water quality, solar circuit
A glycol/water mixture of up to 60 % is permitted for the indirect
coil in the solar circuit, provided only dezincification resistant
metals, glycol resistant gaskets and diaphragm expansion vessels
suitable for glycol are used throughout the system.
9.3

Appliance handover

f Explain the appliance function to users and familiarise them f
with its operation.
f Make the user aware of potential dangers, especially the risk f
of scalding.
f Hand over these instructions. f
18 | SBP 200-700 E | SBP 700 E SOL
10. Appliance shutdown
f Disconnect any electrical accessories installed from the f
mains at the fuse/MCB in the fuse box.
f Drain the appliance. See chapter "Maintenance / Draining the f
appliance".
11. Maintenance
WARNING Electrocution
Carry out all electrical connection and installation work
in accordance with relevant regulations.
If you need to drain the appliance, observe chapter "Draining the
appliance".

11.1 Draining the appliance

WARNING Burns
Hot water may escape during draining.
If the appliance needs to be drained for maintenance or to protect
the whole installation from frost, proceed as follows:
f Close the shut-off valves in the inlet lines. f
f Connect a drain line to the drain valve (not included in stand- f
ard delivery).
f Open the drain valve. f
f When the excess pressure has been released, open the ven- f
tilation facility (see chapter "Specification / Dimensions and
connections") and drain the appliance.
www.stiebel-eltron.com