Troubleshooting - Audio Pro LIVING LV-HUB Bedienungsanleitung

TROUBLESHOOTING

Is the LED light on the LV-HUB blue?
If light is red, try moving the LV-HUB and receiving speakers closer together. Does this turn the LED blue?
Are you using more than one Audio Pro transmitter (TX100, TXD200 or LV-HUB)?
Make sure that the transmitters aren't running on the same House Code. If more than one trasnmitter
uses the same House Code, interference may occur. Disconnect one, or change House Code.
Are you using the same House Code on both transmitter and receiving speakers?
Make sure the same House Code is set on both the transmitter and the speakers.
How far apart are the transmitter and receiver?
If distance between the transmitter and receiver is too far, the, connection might be lost.
Try placing the transmitter and receiver in closer proximity, does this help?
Are there walls between the transmitter and receiver?
If your home has thick concrete walls, or walls of plaster with wire lath, the wireless range will
decrease. Try placing transmitter and receiver in the same room, does this help?
Are there more wireless networks in the area?
If there are many wifi networks running in the area, wireless range can decrease.Try to change the
channel on your wireless router to improve Audio Pro network range and your own home network wifi
performance. (Audio Pro network transmits on channel 1, 6 or 11.)
Is your computer connected to the internet via cable or wifi?
The Audio Pro network can weaken a local wifi network (but not weaken itself). If possible, you should
change channel on your wireless router, the Audio Pro network transmitts on channel 1, 6, or 11.
Choose a new channel on your router, for example 3, 8 or 13. (in total there are 13 channels on the
2.4 GHz band.) If you cannot change the channel on your wireless router, try connecting computer via
Ethernet cable instead. Does this help?
Are there Bluetooth units active in the area?
Shut down all active Bluetooth devices. Does this help?
Windows 7 and Mac OS, sound output
When connecting Audio Pro transmitter to a computer using Windows 7 or Mac OS, you need to select
the sound output. Go to: System settings, find sound settings, and select USB HEADSET as your sound
output. (In older Windows OS there is no need for this, transmitters will take over automatically as the
sound output device.)
10
PAIRING LV-HUB, ONLY WITH FUTURE LIVING SPEAKERS
By pairing, you lock your Audio Pro network from other near by Audio Pro Wireless
networks. Features like changing source in different rooms are available. Pairing fea-
ture is only available on newer Living speakers, not
LV1, LV2, LV2e, LV3 or LV-SUB.
PAIR YOUR LIVING SPEAKERS WITH LV-HUB TRANSMITTER
1. Press Pairing button on LV-HUB for 2 seconds. LED starts to flash Green.
2. Press and hold ZONE/PAIR button on Living speaker for 3 seconds.
On LV speakers
LED starts to flash Green. (See manual for specific LV speaker.)
3. When LEDs on both transmitter and speaker goes to steady green, the system is
paired.
Note:
1. Pairing will not work with older Living speakers (LV1, LV2, LV2E, LV3 or LV-SUB).
2. To unpair system (all speakers in same volume zone will be unpaired):
- Disconnect LV-HUB from power.
Rear on LV-HUB
- While pressing the pairing button, reconnect LV-HUB to power, and hold pairing but-
ton for 6 seconds. All speakers with same House Code will now be unpaired.
11