Cleaning And Maintenance - Waeco CoolFreeze CF16 Bedienungsanleitung

CoolFreeze
➤ Replace the defective fuse (2) with a new one that has the same rating
(T8A 32V).
➤ Re-assemble the plug in the reverse order.
7.1 Replacing the bulb (CF16, CF26)
➤ Press the switch pin (fig. 6 2, page 4) downwards so that the transpar-
ent part (fig. 6 1, page 4) of the lamp can be removed at the front.
➤ Replace the light bulb.
➤ Press the lamp back into the housing.
8

Cleaning and maintenance

!
WARNING!
Always disconnect the device from the power supply before you
clean and service it.
A
NOTICE! Risk of damage
 Never clean the cooler under running water or in dish water.
 Do not use abrasive cleaning agents or hard objects during
cleaning as these can damage the cooler.
➤ Occasionally clean the device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any
dust and dirt, so that heat can be released and the device is not damaged.
EN
Cleaning and maintenance
33