Led Brightness - Mobeartec RaceControl pro Benutzerhandbuch

Therefore, please press and hold the button B1, until the
LED's start to blink (after some seconds). While still holding
B1, you can press and release the green button B6 (to
select 'keyboard mode') or the button next to the green
button on the left-hand side (for 'game controller mode').
After that, please release B1. The controller starts up again
using the desired mode.

4.5 LED brightness

During the LED's are blinking (please refer to 4.4), you can
also adjust the general brightness of the LED's by turning
the big knob (R1). The new brightness setting is stored
automatically.
5 Usage in Simracing
The configuration inside your simulation software is usually
very easy. There is always a setup of controls where a
specific setting (let's say 'engage wiper' here) can be
clicked using the mouse, and then use the control on your
Racecontrol pro, to tell the PC that this button, switch or
rotary know shall be used for the action selected.
6 Important safety precautions
This product is for indoor use only.
•
Do not expose to dust, direct sunlight, wet weather
•
conditions, high humidity, high temperature, mecha-
nical shock or heavy vibrations as this might damage
electronic components.
Do not expose the product to splashing, dripping rain,
•
snow or moisture. Do not immerse in liquid.