Using The Vacuum Cleaner; Charging The Battery - Waeco PoverVac PV100 Bedienungsanleitung

PowerVac PV100
➤ Bolt strap into position using bolts provided (fig. 6 3, page 3).
7

Using the vacuum cleaner

7.1

Charging the battery

NOTICE!
A
Charge the battery only with the included mains adapter or the 12 V
charge cable. Should you need spare parts, please order them ex-
clusively from the manufacturer.
The battery is fully charged after 10 to 14 hours (when charged from the
mains adapter). You do not have to monitor the charging process; the
integrated charge electronics will terminate the procedure automatically.
NOTE
I
Please note that when charging from your vehicle's on-board 12 V
supply, the battery is only partially charged. The charge level of the
battery depends on the available battery voltage (see "Technical in-
formation" on page 31).
Please note the following:
 Charge the battery only at an ambient temperature of 0 °C to +40 °C
so that the battery can be fully charged.
 The power supply heats up during the charging process.
 Do not switch on the device during the charging process.
Proceed as follows to charge the battery from the 230 V AC mains
(see fig. 3, page 3):
➤ Put the plug of the power supply (fig. 3 1, page 3) into the charging
socket of the vacuum cleaner (fig. 3 2, page 3).
➤ Plug the power supply into a 230 V mains outlet.
✓ The charge display (fig. 2 3, page 2) lights up, and battery charging
begins.
✓ Once the charge display (fig. 2 3, page 2) is no longer lit, the battery is
fully charged.
EN
Using the vacuum cleaner
25