D-Link DCS-4602EV Installationsanleitung Seite 12

Waterproofing Your Installation
To waterproof your camera installation, follow the instructions below. Round Ethernet
cable, a crimping tool, and RJ-45 plugs are required for this procedure.
Place the washer around the base of the Ethernet
connector as shown.
Thread bare Ethernet cable through the waterproof
connector as shown, then crimp an RJ-45 plug onto the
cable.
Connect the RJ-45 plug into the Ethernet connector, then
screw the waterproof connector to the Ethernet connector
by turning it about a half-turn clockwise.
10
D-Link DCS-4602EV Quick Installation Guide