Automatic Standard Cooking Programmes - Schneider EDOM - 34 Bedienungsanleitung

1. If the steam cooking process is completed, the water from the internal boiler
will be pumped back into the water tank. This induced normal operating noise.
2. The pumping process takes 1 minute approx.
3. Always empty the water tank after the pumping process has been completed.
 If the water tank is full during the pumping process but there is still water
remaining in the internal boiler, an acoustic signal sounds ten times to indicate
that the water tank must be emptied. If the water tank has been emptied, the
pumping process will be continued.
Always dry the cooking compartment as well as the door of the appliance after
the steam cooking process is completed using a soft and dry cloth.

6.1 Automatic standard cooking programmes

 The available automatic standard cooking programmes are listed in the
following table.
Using of automatic cooking programmes incl. preheating function (e.g. P 09 /
P 11 / etc. // s. table below):
 Do not place the foods to be cooked in the appliance at the beginning of the
operation but only when the preheating process is complete.
For cooking in the automatic cooking modes use microwavable ovenware only
(s. also chapter 7.2 S
chapter 7.3 U
NSUITABLE MATERIALS FOR MICROWAVE COOKING
WARNING! Do not use the appliance in the automatic cooking mode
when it is empty.
CAUTION! Cooking utensils may become hot because of the heat
transferred by the heated food. Potholders or oven gloves may be
needed to handle such utensils.
A
FTER STEAM COOKING
UITABLE MATERIALS FOR MICROWAVE COOKING
:
).
and
146