®
OBID
ID ISC.SAT.C, ID ISC.SAT.A and ID ISC.SAT.B
14. Structure and tuning of a single- and gate-antenna
Notes for the setting up and for adjustment of standard configurations with FEIG-antennas can be
seen in the appropriate Mounting Instructions and Application Notes on the OBID
i-scan CD of
FEIG ELECTRONIC.
14.1. Structure of a base antenna
Figure 12 shows the dimensions of a possible antenna made of RG214-cable. Here only the shield
will be connected as conductor. The centre contuctor is not used. For the installation of Tuner ID
ISC.SAT.A for the base antenna or ID ISC.SAT.B for the complementary antenna, about 10mm of
the insulation of the cable ends should be stripped.
Figure 12: Dimensions of a base antenna
All dimensions in millimetres
600
800
ID ISC.SAT.A
FEIG ELECTRONIC GmbH
Page 47 of 54