Amplicomms RingFlash 100 Bedienungsanleitung Seite 29

Starting Up
Check the contents of the package
Contents
RingFlash unit
Power adaptor plug
Telephone connection
cable
Doorbell unit
12 Volt battery
Fixing screws and wall
plugs
Operating Manual
Connecting the base
RF100 RF200
1 1
1 1
1 1
Receiver connection
0 1
0 1
0 4
1 1
Connect the base as illustrated in
the diagram. For reasons of safety,
only use the power adaptor plug and
telephone connection cable supplied.
As soon as you switch the mains
power on, the RingFlash unit will beep
to confirm that it has been installed
correctly. If you do not hear a beep,
please unplug the power connection,
wait for 1 minute and then plug in the
power again.
Starting Up
Mains power outlet
GB
29