Control Panel; System Limitations - Mobileye C2-270 Kurzanleitung

Mode Selection
1
Turning OFF: to turn off the mobileye c2-270 press the (
until the EyeWatch display turns off or long press on the (-) button on the
camera.
Turning ON: to turn on the mobileye c2-270, press on any button.
Changing the EyeWatch display brightness level:
(1) press the (
increase the brightness level. there are 5 available levels (1-5). the c2-270
automatically adjusts brightness levels for day and night.
Changing the Headway Warning Timing:
(1) press the (
increase it.
Changing LDW Sensitivity:
sensitivity, or press (+) to increase it.
Changing PCW Sensitivity:
press (+) to increase it. there are 3 available levels. level 0- disables pcW warnings. level 1- less sensitive (pedestrian
alert would be given up to 10m). level 2- more sensitive (pedestrian alert would be given up to 30m).
Volume Control (-) (+)
2
press the (-) button (repeatedly) to decrease volume. press the (+) button (repeatedly)
to increase volume. there are 6 volume levels (0-5). note: When the volume is set to
zero the ldW and hm sounds are disabled, but fcW sound is set to level "3".
Mute
3
Option 1: Set volume level to "0", either from the EyeWatch display or from the camera control button.
Option 2: to mute press and hold the (-) button on the EyeWatch for 1.5 seconds.
to exit mute press (+)
mute mode is indicated by a flashing green dot in the lower part of the display unit.
muting will disable the hW and ldW audio alerts. fcW cannot be muted
Virtual Bumper Sensitivity (VB)
4
to change the Virtual Bumper sensitivity press and hold the (+) button and then press on the (-) button
for 1.5 sec. a red car icon will start flashing and the numerical display will show. press the (-) to decrease
the VB sensitivity, or press (+) to increase it. the VB sensitivity is limited between 0.5 meters and 2
meters. this feature is available only when speed is "0".

SYSTEM LIMITATIONS

mobileye c2-270 is intended for paved roads, with clear lane markings.
l
mobileye c2-270 does not see better than the driver. it is the driver's responsibility to always be alert, and always
l
depend on their own eyesight and full attention and awareness when driving the vehicle.
mobileye c2-270 detects fully visible rear ends of vehicles. therefore the detection of crossing, oncoming, and
l
passing vehicles, is not supported.
mobileye c2-270 does not guarantee 100% accuracy in the detection of vehicles or driving lanes, nor in
l
providing warnings of all potential road hazards. in addition, road, weather and other conditions can adversely
effect the mobileye c2-270 system's recognition and response capabilities.
any conditions that form partial or full blockage of the camera's view will result in reduced or non-functionality of
l
mobileye c2-270. always ensure the camera has a clear field of view.

Control Panel

Turning the Mobileye C2-270 OFF/ON
) once. (2) press the (-) (+) buttons to decrease or
) twice. (2) press (-) to decrease the headway warning timing, or press (+) to
(1) press the (
(1) press the
) button
) 3 times. (2) press the (-) to decrease the ldW
( )
4 times. (2) press the (-) to decrease the pcW Sensitivity, or