Important Hints; Warranty And Repair - Hameg Instruments Ho870 Handbuch

I m p o r t a n t h i n t s

Important hints

Security
This instrument has been designed and tested
in accor dance with IEC Publication 1010-1,
Safety require ments for electrical equipment
for measurement, control and laboratory use. It
corresponds as well to the the CENELEC regu-
lations EN 61010-1. All case and chassis parts
are connected to the safety earth conductor.
Corresponding to Safety Class 1 regulations
(three-conductor AC power cable).
Do not disconnect the safety ground either inside
or outside of the instrument!
The istrument must be disconnected and secured
against unintentional operation if there is any
suggestion that safe operation is not possible.
This may occur:
– if the instrument shows visible damage,
– if the instrument has loose parts.
– if the instrument does not function,
– after long storage under unfavourable
circumstances (e.g. outdoors or in moist
environments).
When removing or replacing the metal case, the
instrument must be completely disconnected
from the mains supply.

Warranty and Repair

HAMEG instruments are subjected to a strict
quality control. Prior to leaving the factory,
each instrument is burnt-in for 10 hours. By
intermittent operation during this period almost
all defects are detected. Following the burn-in,
each instrument is tested for function and quality,
the specifi cations are checked in all operating
modes; the test gear is calibrated to national
standards.
The warranty standards applicable are those of
the country in which the instrument was sold.
Reclamations should be directed to the dealer.
Only valid in EU countries
In order to speed reclamations customers in EU
countries may also contact HAMEG directly. Also,
8
Subject to change without notice
after the warranty expired, the HAMEG service
will be at your disposal for any repairs.
Return material authorization (RMA):
Prior to returning an instrument to HAMEG ask
for a RMA number either by internet (http://www.
hameg.com) or fax. If you do not have an original
shipping carton, you may obtain one by calling the
HAMEG service dept (+49-6182-800-500) or by
sending an email to service@hameg.com.
USB
The interface is equipped with a Type A USB
female connector. For direct connection with a
host controller or an indirect connection via an
USB hub, an USB cable is required, equipped
with Type B male connector one end and a Type
A male connector at the other.
Type A Type B