Indirect Measurement - Coitech CA770 Bedienungsanleitung

3
6
3. Point the laser over the area to be measured to measure length and press
to measure (a short beep will be heard once the measurement has been taken).
4. The measured distance will be shown on the display.
5. Point the laser over the area to be measured, in the other direction and press
to measure width (a short beep will be heard once the measurement has been taken).
6. Point the laser vertically on the surface of the area to be measured and press
to measure height (a short beep will be heard once the measurement has been taken).
7. The two previous readings will appear on top. The sum is shown at the bottom of the display.

4.3 Indirect measurement

Follow the instructions on the display. The corresponding symbol for what is to be measured
will flash on screen.
The meter uses Pythagoras' formula (a² + b² = c²) to measure height indirectly.
1
1. Press to turn on the distance meter and laser. The laser indicator will display when
the laser is on.
2. Press to select indirect measurement (a triangle symbol will show in the display).
3. Point the laser to the highest point of the object to be measured (the triangle's hypotenuse
will flash) Press
4. Point the laser directly parallel to the object to be measured (the triangle's base will flash).
Press to start measuring.
5. The height (the triangle's vertical line will begin to flash) is calculated automatically and
will be shown on the display.
4
5
3
2
to register the first reading.
9
5 7
4
once
again