K&M Safe-T-Lock Anleitung Seite 29

Typical Operation
1. Enter two digit user ID followed by 4-8 digit PIN.
Note: Default user PIN is 1 2 3 4 (this PIN can be changed as explained below)
2. Press Power/Enter Key > High pitch tone and green LED indicate unit is activated and vehicle is ready
for use. While lock is active, the Green (Accept) LED will occasionally flash indicating electronic lock is
enabled.
Change of User PIN
1. Enter two digit user code followed by 4-8 digit PIN.
2. Press Power/Enter Key > High pitch tone and green LED indicate unit is activated. Green (Accept) LED
will occasionally flash indicating electronic lock is enabled.
Note: During the following procedures vehicle output is deactivated.
3. Press 1 followed by Power/Enter key (within one minute of user entry). > Red Program LED flashes once
with key entry.
4. Press new PIN followed by Enter/Power key. > Green Accept LED flashes once with key.
5. Re-enter new PIN followed again by Power/Enter key. > Green and Red LEDs will simultaneously flash
along with high pitch acceptance tone.
6. New PIN can now be used to access vehicle.
Disabling Vehicle
Three options:
1. Press Power/Enter Key
2. Turn truck ignition off. (See wiring diagram for units with key switch)
3. Automatic Time-Out: Absence of positive or negative voltage on gray wire will cause unit to
automatically shut off after three minute period. (See wiring diagrams)
Safe-T-Lock
USER OPERATION
5