OSRAM HF LS LI Installations- Und Bedienungsanleitung Seite 12

3.3 Setting vibration sensitivity
Set vibration sensitivity to avoid erroneous triggering caused by vibration:
Press the [PROG] button (VLP) to start programming mode.
1.
Press (SP) the button [2] (inner ring segment on the remote control) to select configuration
2.
of vibration sensitivity.
Set vibration sensitivity (see table) by pressing (SP) buttons [15] to [20].
3.
4. Exit programming mode by pressing (SP) the [PROG] button or exit automatically 60 sec-
onds after the last detected movement.
Vibration sensitivity
Vibration detection off
Min
Mean (works setting)
High
Very high
Max
Table: Vibration sensitivity settings
Important note:
After installation or after modifying the position/realigning of the sensor, setting vibration sensitiv-
ity is mandatory before normal motion detection is active.
12
Button event
Press button [20] (SP)
Press button [15] (SP)
Press button [16] (SP)
Press button [17] (SP)
Press button [18] (SP)
Press button [19] (SP)
3.4 Sensor LED signals
LED display (red / green), 4 (3):

LED signal
Green LED flashes
Green LED illuminates continuously
Red LED flashes 3 times
Red LED flashes 1 time
Red LED illuminates continuously
Table: LED signals
3.5 Configuration of DALIeco control unit
separate instructions

4 Accessories
1b

(1) 4p4c connecting cables,
pre-assembled connecting cable, (50 pc. pack)
0.25 m: 4008321660145 0.5 m: 4008321660152
1.0 m: 4008321660169 2.0 m: 4008321660190
(2) DALIeco control,
2-ch. DALI control unit for installing in luminaire and ceiling, 4008321988645
(3) User remote,
user remote control, 4008321826435
(4) Master remote
Configuration remote control, 4008321988669
Meaning
Motion detected
Holiday mode active (motion detection
temporarily deactivated)
IR signal of remote control received
Vibration detected*
100h burn-in active