OSRAM HF LS LI Installations- Und Bedienungsanleitung Seite 11

3 Function and settings
3.1 Master Remote remote control (
6
1 sec
9
3 min
12
15 min
Macro Recorder
2
5
3
100 h
Burn-in
ON
OFF
CH-1
Stand-by-level
OFF
15
Stand-by-time
30 s
16
15 min
17
18 60 min
19
20
separate instructions)

7
8
ON
Sensor
select
OFF
10
test Switch o delay
30 sec 1 min
11
5 min 10 min
13
30 min 60 min
14
1
PROG
4
O set
PC modes
1 2 ON
OFF
CH-2
Auto
setup
Manual
setup
10 % 30 % 50 %
5 min ON ON
Semi Semi
30 min
Auto Auto
OFF OFF
3.2 Manual configuration of detection range
1. Press the [PROG] button (VLP) to start programming mode.
Press button [3] of the inner ring segment (SP) for manual configuration of the detection
2.
range. This automatically sets the range to the mean value.
Modify the range according to the table below by pressing (SP) the buttons [4], [5] and [7]
3.
to [14].
4. Exit manual configuration by pressing (LP) the button [PROG] or automatically 60s after the
last detected motion.
Detection sensitivity / range
-5 (minimum)
-4
-3
-2
-1
0 (mean)
+1
+2
+3
+4
+5 (maximum)
Table: Detection sensitivity settings
Testing detection sensitivity:
Press the [PROG] button (VLP) to start programming mode.
1.
2. Select test mode by pressing (SP) the [6] button.
3. Start test mode by pressing (SP) the [PROG] button.
4. Test mode of control unit for 60 seconds: Lighting (maximum) as soon as motion has been
detected. Change 1s after the last movement back to minimum. Test mode duration is reset
to 60 seconds after each movement.
Exit test mode by pressing (SP) the [PROG] button or exit automatically 60 seconds after
5.
the last detected movement.
Button action
Press button [5] (SP)
Press button [7] (SP)
Press button [8] (SP)
Press button [9] (SP)
Press button [10] (SP)
Press button [3] (SP)
Press button [11] (SP)
Press button [12] (SP)
Press button [13] (SP)
Press button [14] (SP)
Press button [4] (SP)
11