Pairing A Bluetooth Device - Marantz professional Voice Rover Benutzerhandbuch

Operation
Wireless Mic Setup
To use the included wireless mic, follow these setup steps:
1. Ensure 2 new AA alkaline batteries are installed in the wireless mic (see the battery
installation side graphic). The microphone handle unscrews to reveal the battery
compartment. Screw the handle back on with the threads facing inward.
2. On the UHF Receiver panel on Voice Rover, turn on Power-Vol knob clockwise.
3. Turn on the wireless microphone using the switch found on the bottom of the
microphone. Watch the AF indicator to make sure a signal is being received.
4. Use the Up or Down buttons to select a wireless channel that gives a strong signal.
5. Hold the microphone close to your mouth when speaking and the AF LED will
illuminate on the Wireless Mic Settings panel. Adjust the Power-Volume knob to
increase the level.
Note: If needed, the High/Low (H/L) switch on the wireless mic (see the side graphic)
can be adjusted to increase the signal range. The High power setting consumes more
battery power to
extends battery life for use in scenarios where a lower operating range is acceptable.
Note: If needed, the gain adjustment on the microphone can be adjusted clockwise for
more output gain. For less output gain, the screw can be adjusted counter-clockwise.
Mute Level
In most situations this should be left at the factory preset position. However, in cases of high
RF activity, the mute levels can be re-adjusted to suppress interference from other wireless
devices in a shared RF environment. This will reduce interference when an audio signal is not
present. If the AF or RF LEDs flicker or stay on when the wireless microphone is off, the
Mute Level screw on the UHF receiver panel should be turned counter-clockwise until the
LEDs are off. When the Mute Level is properly adjusted, the corresponding AF and RF LEDs
will light up only when the wireless microphone is being used.
Setting ASC (Auto-Sync Channel)
If you receive interference or if another channel is needed, select another channel using the
ASC (Auto-Sync Channel) button.
1. Select the UHF channel you want to use with the best reception using the Up or Down
buttons.
2. Turn the microphone on and place the microphone's sensor (found above the battery
compartment, seen in the graphic above) near Voice Rover's IR LED.
3. Press the ASC button once on Voice Rover and wait for about 3 seconds, until the IR
LED stops flashing. When it finds an interference-free channel, the wireless mic will be
matched to that channel.

Pairing a Bluetooth Device

1. Turn on your Bluetooth device.
2. Power on Voice Rover.
3. Navigate to your Bluetooth device's setup screen, select Bluetooth which is the Voice Rover speaker, and
connect.
Note: If prompted for a passcode, enter 0000.
4. Play music from your Bluetooth device.
5. Adjust the volume from Voice Rover by holding down the |<< or >>| button to decrease or increase the volume.
6. To disconnect pairing, turn off Bluetooth on your device or select "Delete paired info" from the Voice Rover
Bluetooth menu.
6
provide extended range and reception. The Low setting