Elos Me Benutzerhandbuch Seite 18

treating with
3
3
5
6
* Sold separately or included with your mē system
How to use:
1. Clean your skin and remove the hair on the surface
of the skin. You may remove the hair on your face with
tweezers, wax, shaver, etc. but not with an epilator.
2. Use a broad ambient light environment. Turn on your
device. Select the LOW
device will not work if you do not select an
3. If you find the light from the elōs flash too bright, you
can wear sunglasses or goggles for your comfort.
With a precision adaptor*
4. Remove the accessory protective cap and connect
the precision adaptor. The precision adaptor will allow the
system to emit only single pulses with the desired energy
level.
5. Press the
cartridge activation button on the
applicator to turn on the applicator. Gently position the
applicator on the area you want to treat. Press once the
activation button to emit a single pulse.
6. Reposition the applicator on the next area to be
treated and press the
another pulse. Repeat these previous steps until you have
covered the entire facial area. Wait at least 10 seconds
before you treat over the same spot.
Without a precision adaptor
4. Press the
activation button on the applicator to
turn on the applicator. Gently position the applicator on
the area you want to treat. Upon contact - a pulse will be
emitted. Remove the applicator after a single pulse.
5. Reposition the applicator on the next area to be
level on the base unit. The
activation button again to emit
setting.
EN 18