Batterien Einlegen; Fernbedienung Verwenden - Megasat HD500se Bedienungsanleitung

Batterien einlegen

Entfernen Sie die Batteriefachabdeckung von der Fernbedienung und legen
Sie 2 x AAA
Batterien in das Batteriefach.
Die Aufdrucke im Batteriefach zeigen, wie die Batterien korrekt eingelegt
werden müssen.
1. Abdeckung öffnen 2 Batterien einlegen 3. Abdeckung schließen

Fernbedienung verwenden

Um die Fernbedienung zu verwenden, richten Sie diese direkt auf die
Vorderseite der Set Top Box. Die Reichweite der Fernbedienung beträgt bis
zu 7 Meter von der Set Top Box bei einem Winkel von bis zu 60 Grad.
Blind Scan
First scan the band to get the transponders which can be locked. After
gathering all Transponders, Scan the transponders one by one to get the
programs.
4.3.2 Transponder
Press GOTO to switch the list to show transponders of the focused satellite.
Also you can press GOTO to switch back to satellites' list.
Add transponder: Press Red to add a new transponder. It can't save an
existing TP under the same satellite.
Edit transponder: Press Green to edit the focused transponder. It can't save
an existing TP under the same satellite.
Delete transponder: Press Yellow to delete the focused transponder. Press
OK to confirm.
Single Transponder Scan: Press Blue to pop the menu of scanning setting.
After configuring the settings, Press OK to start scanning.
Multi-Transponder Scan: Press OK to select transponders with the mark" ",
then press blue to pop the menu of scanning setting. After Configuring
the settings, press OK to start multi-transponder scanning.
4.3.3Unicable
Unicable enables the delivery of broadcast programming to multiple users
over a single coaxial cable. It should work with Unicable LNB or SaTCR
equipment. Set the Unicable ON, and select a channel which isn't occupied
by other users. Dish setup with Unicable When unicable activated, the
DiSEqC1.0, DiSEqC1.1, DiSEqC1.2,DiSEqC1.3 are disabled. Set Pos A/B for
satellites if the equipment can support.