THOMSON WHP3326 Bedienungsanleitung Seite 4

G Operating Instructions
Thank you for choosing a Thomson product.
Take your time and read the following instructions and
information completely. Please keep these instructions in a
safe place for future reference. If you sell the device, please
pass these operating instructions on to the new owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to
draw your attention to specific hazards and risks.
Note
This symbol is used to indicate additional information or
important notes.
2. Overview
Transmitter/charging station – Fig. 1 A
1. Charge status LED indicator (red)
2. Power/signal LED indicator (green)
3. Charging contacts
4. DC socket for power supply
5. RCA audio input sockets
6. Frequency channel switch
Receiver/headphones – Fig. 2 B
7. Power on/off switch
8. Power LED indicator
9. Volume control
10. Autotune button
11. Signal LED indicator
12. Charging contacts
13. Battery compartment
3. Package contents
• 1 WHP3326 UHF wireless headphones
• 1 transmitter with charging station
• 2 NiMH AAA batteries
• 1 power supply unit
• 1 audio adapter cable, RCA stereo to 3.5 mm jack
• 1 jack adapter 6.3 mm/3.5 mm
2
4. Safety Notes
Warning
• Using this product limits your perception of ambient
noise. For this reason, do not operate any vehicles or
machines while using this product.
• Always keep the volume at a reasonable
level. Loud volumes, even over short
periods, can cause hearing loss.
• Never open, damage or swallow batteries or allow them
to enter the environment. They can contain toxic, environ-
mentally unfriendly heavy metals.
• Do not tamper with or damage/heat/disassemble the
batteries/rechargeable batteries.
• The product is intended for private, non-commercial use
only.
• Use the product for its intended purpose only.
• Children should be supervised to ensure that they do not
play with the device.
• Do not use the product in areas where the use of elec-
tronic devices is not permitted.
• Only connect the product to a socket that has been ap-
proved for the device. The socket must be installed close
to the product and easily accessible.
• Disconnect the product from the network using the power
button – if this is not available, unplug the power cord
from the socket.
• Lay all cables so that they do not pose a tripping hazard.
• Do not bend or crush the cable.
• Do not drop the product and do not expose it to any
major shocks.
• Dispose of packaging material immediately according to
locally applicable regulations.
• Do not modify the product in any way. Doing so voids the
warranty.
• Do not use the product if the adapter, connection cable
or power cable is damaged.
• Do not attempt to service or repair the product yourself.
Leave any and all service work to qualified experts.
• Do not open the device or continue to operate it if it
becomes damaged.