Raptor 051711 Benutzerhandbuch Seite 11

5. Press M again to make the month flash. While it flashes, change it with
the or
6. Press M again to make the day flash. While it flashes, change it with
the or
7. Press M again to change the time mode from 12 to 24 hour or vice
versa. While it flashes, change it with the
At any time, press CAL to exit and save the changes you've made.
TE (Thermometer):
The temperature appears in the upper right corner of the display. To switch between
Fahrenheit and Centigrade or vice versa, press the M button for 3 seconds.
AT (Altimeter)
The altimeter is shown in feet or meters on the lower right corner of the display.
1. Press the M button for 3 seconds to change from feet to meters or
vice versa. Do a quick press of the CAL button to update the new
height data.
2. Pressing CAL for 3 seconds enters the set mode. CAL appears in the
upper right of the display and pressing the
adjusting of the height data. Note that a – (minus) appears at the
bottom left of the display to indicate negative feet or meters. Press
the CAL button to exit.
3. Pressing MEM for 3 seconds enters memory mode. While MEMORY
flashes at the top of the display, pressing the
allows selection of the memory (top right of display) to save the
current height data. A quick, press and release of the MEM button
saves the current height.
buttons.
buttons.
T1
or buttons.
or buttons allow
or buttons
M
9