Safety Cautions; Product Description - Beper 40.963 Betriebsanleitung

Hair Curling Use instructions

SAFETY CAUTIONS

1. Do not block the air intake or outlet areas during use. Blocking the air flow can result in overhe-
ating which may cause burns or mechanical damage. Rolling too large a bunch of hair around the
brush will not allow proper curling and also block the air outlet.
2. If the air intake is blocked by the hand during use, for example, the thermal switch may function
and turn off the device. This does not mean the device has been damaged and it should shortly
return to normal. However, repetition of this sequence can result in damage.
3. When the styler is switched on, do not leave it near bedding, paper or other combustible objects.
Also, do not use the styler near gas or other highly combustible items.
4. Avoid dropping or subjecting the device to excessive shock. Do not pull the cord with unnecessary
force.
5. After use, switch the styler off then unplug the cord from the receptacle.
6. Wipe the housing clean with neutral detergent. Do not use thinner or benzine. Do not directly
apply hair oils or lotions to the brush or comb.(Indirect contact from the hair is permissible.) Do not
store near such cosmetics as they may deform the housing, comb and brush.
7. Do not use in a bath area or with wet hands. Do not store in a damp area.
8. If damage occurs during use, the motor does not function properly, the warm air flow stops, or
other abnormality occurs, cut off the power supply immediately and have the device repaired by an
authorized repairman. Do not tamper with the inner mechanism.
9. If the supply cord is damaged it must be repaired by the Authorized Service Agent.
10. This appliance must be installed following the national regulations for electrical installations.
11. - The appliance isn't destined for the use of children or person with physical or mental problems
and without experience nor knowledge; unless they make it down control of a responsible or profes-
sional for the use of the appliance.
12. - WARNING: In order to ensure your children's safety, please keep all packaging (plastic bags,
boxes, polystyrene etc.) out of their reach.

PRODUCT DESCRIPTION

1. Cool tip
2. Curling rod
3. On/off light
4. On/off switch
5. Swivel cord
COMMISSIONING
1. Remove all the packing materials.
2. Insert the plug in a duly installed 230 V/50 Hz socket.
3. Switch on the appliance:
Position 0: Off
Position 1: On
4. Switch off the appliance after use and pull out the plug. Leave it cool for a few minutes
before putting it away.
8