Programming A Keypad With Touch Screen - hager S761-22 Montageanleitung

Programming

Programming a keypad with touch screen

• 1 st possibility for use
Press the
remote-controlled
socket
programming
key (for less
than 2 sec.).
The programming
LED will light
up temporarily.
If the Light or Socket keys are then re-programmed for
Toggle Switch mode, the keypad must be programmed
G
again (see keypad with touch screen manual).
B
If you make a programming error, the programming LED will flash quickly. You must carry out the programming
sequence again from the start.
Press and hold the
remote-controlled
Light ON
socket confirms
or
programming
Socket ON
programming
key on the Light
LED lighting
page until the
up for 2 sec.
remote-controlled
socket programming
LED lights up.
• 2 nd possibility for use
The Light page
programmed for direct access (see Keypad
installation manual).
The
by its
Press the
remote-controlled
socket
programming
key (for less
than 2 sec.).
The programming
LED will light
up temporarily.
96
access key must first be
Press and hold the
remote-controlled
socket confirms
key on the Light programming
page until the
remote-controlled programming
socket programming LED lighting
LED lights up. up for 2 sec.
The
by its