FCOE LinX Bedienungsanleitung Seite 6

Using the FCOΞ LinX 433MHz Set
Switch on the cam and plug in the receiver. The camera head moves to the new
zero position. Switch on the transmitter – according to your requirements: camera
standing on base plate: regularly - to the left, camera hanging on base plate:
inverse – to the right.
Now you can pan the head with the transmitter for 170° and tilt for 120° . Return
the cam's head back to the basic position by pressing the transmitter buttons B &
C simultaneous. Pressing these buttons again turns the head to the selected zero
position.
The transmitting range to the receiver is about 300 meters/1000 feet.
Fully charged, the transmitter can be used for approximately 5 hours.
If the receiver goes out of range, the red LED of the transmitter starts blinking.
Usage of the FCOΞ LinX 433MHz Set with the FCOΞ V-Eyes
Insert the transmitter into the V- Eye´s docking station and use it as mentioned
above.
How to charge the FCOΞ LinX transmitter.
To charge the transmitter, connect it to the USB AC/DC adaptor cable or the USB-
cable that comes with the core set. It can also be charged in the docking station of
the FCOΞ V-Eyes. Charging will take about 30 minutes. When charging is
completed the red LED light will turn into blue.
Limited warranty of the LiPo battery.
The LiPo battery included with this product will give good service but will slowly
wear out over time. If mistreated by improper use, storage or handling the battery
life will be much shorter.
Battery wear is not covered by warranty.
V.1.02 www.FlyCamOne.com