Lindy 35401 Benutzerhandbuch Seite 3

Manual
Introduction
Thank you for purchasing the LINDY VGA & Audio Cat.5e/6 4 Port Extender. This extender allows you to transmit
VGA video and analogue audio up to a distance of 300m using high quality Cat.5e/6 solid core cable to 4 remote
receivers with monitors/projectors and speakers connected. An optional skew compensation unit (like LINDY No.
32766) can be used to correct colour shadows on the display caused by different lengths of RGB signal
transmission over the twisted pairs in the Cat.5e/6 cable.
Package Content
No. 35401:

VGA & Audio Cat.5e/6 4 ports Extender –
Transmitter unit

5V DC ~2A Multi Country power supply

User manual
Features

Supports display resolutions up to 1920x1200@60Hz or 1600x1200@60hz or 2048x1536@60Hz

Supports output of mono audio signals (left and right stereo channels are combined)

The transmitter unit integrates a 4 ports video splitter to distribute the signal to up to 4 remote receiver units

Allows video & audio signals to be extended up to a maximum distance of 300m via high quality solid core
Cat.5e/6 cables. A skew compensation unit like LINDY no. 32766 may be required to get the best image
quality especially at very large cable distances.

Gain and Peak adjustment option on the receiver unit No. 35402.

Supports local monitor and speakers out ports on the transmitter unit No.35401
Installation and Operation
Please switch off all the devices involved in the installation before starting to make any connection.
NOTE: All cables listed in the following procedure can be found and bought directly on the LINDY website.
NOTE: Please use short VGA and audio cables (i.e. 1m) to ensure the best results
NOTE: Using additional RJ45 plug/receptacle connections as well as the use of stranded cores patch cables
in the Cat.5e/6 connection will reduce the maximum distance significantly!
For the installation please use the following steps:
1) Connect the remote displays / projectors and speakers to the receiver units with a standard VGA
(male / male) cable and (if needed) a standard audio cable with 3.5mm Stereo jack connectors.
2) Connect the RJ45 connectors of the Cat.5e/6 cables to all the receiver units to be installed
3) Connect the RJ45 connectors on the other side of the Cat.5e cables to one of the 4 RJ45 ports of the
transmitter unit
4) Connect the local display / projector and speakers to the OUTPUT ports on transmitter unit using a
standard VGA (male / male) cable and a standard audio cable with 3.5mm Stereo jack connectors.
5) Connect the VGA video source and audio source to the related INPUT ports on the transmitter unit
using a standard VGA (male / male) cable and (if needed) a standard audio cable with 3.5mm Stereo
jack connectors.
6) Connect the Power Supply Units to the DC power ports on both the transmitter and receivers units
and then to the mains power socket.
7) Switch on all the other devices.
No. 35402:

VGA & Audio Cat. 5e/6 Extender – single
Receiver unit

5V DC ~1A Multi Country power supply

User manual
1
English