Initial Operation - Me bg-1 Bedienungsanleitung

BG-1
| ENGLISH
OPERATING INSTRUCTIONS BG-1
Thank you for purchasing the wireless doorbell
BG-1. Please read this instruction manual
carefully and keep it for later use.
Legend
1. Receiver
2. LED
3. Loudspeaker
4. Melody button
5. Volume button
6. Code button
7. Transmitter
8. Nameplate
9. Bell push-button
TRANSMITTER
Opening the transmitter and inserting
the battery
1. The transmitter has a small slot on its side
to open the enclosure. Insert a screwdriver
in the enclosure slot and turn gently to open
the enclosure.
2. Remove screw (A) and remove the board.
3. Remove the old battery and insert a new
one (type CR 2032) into the battery holder
with the positive pole facing upward.
4. Put the board back in place and fix it again
with the screw (A).
5. Reassemble the housing. The transmitter is
now ready for use.
Mounting the transmitter
Each transmitter may be mounted either by me-
ans of the included double sided adhesive tape
or with screws. The transmitter should not be
mounted on metal since this would significantly
limit the range. Provisionally mount and test the
transmitter before mounting in its final position.
Use the pre-punched holes on the back of the
enclosure should you mount the transmitter
with screws. These holes are closed ex-factory to
prevent moisture from entering the transmitter
should the latter be mounted using only double-
sided adhesive tape. These holes may simply be
pierced with the screw. Screws and dowels are
not included in delivery.
RECEIVER

Initial operation

In order to operate the receiver plug it in to a
regular, easily accessible mains socket. Then
carry out the item 'Coding'.
Coding
Once the receiver is plugged in it is automati-
cally in learning mode. Press each bell button
(transmitter) that is to be learned within 40
seconds of plugging the receiver. If no bell
button is pressed within these 40 seconds then
the receiver will remain in learn mode until a bell
button is pressed.
10