GEV Q10 Betriebsanleitung Seite 11

Table of functions
Red LED Green LED
Flashes briefly -
approximately
every 5 min
Flashes approx. -
twice per second
Flashes approx. -
every 10 seconds
Flashes approx. -
every 10 seconds
Flashes approx. -
every 5 min
- Flashes 3x
every 43
seconds for 24
hours
Sound Description
- Ready/normal mode
Smoke alarm device is working
correctly and is ready for
smoke detection.
Intermittent alarm Alarm is triggered when
signal smoke is detected.
No signal Temporary silencing of the
alarm
is activated for 10 ± 1 min.
3 short beeps in 43 Error/sensor fault/end of life
seconds
Tone every 43 Fault signal emitted by the
seconds smoke alarm device when
battery is discharged
No signal Alarm memory for the next 24
hours
11
Solution
Briefly press the button to
temporarily silence the alarm
preventatively for 10 ± 1 minutes.
Temporarily silence the alarm for
10 ± 1 minutes by briefly pressing
the button.
Silent mode can be cancelled by
initiating the test function: Press
and hold the button (min. 3 sec.)
until a loud, pulsating alarm signal
sounds.
Replace the device
Replace the device
The alarm memory can be
cancelled by pressing the silencing
button.