Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7. Installation
Proceed as follows when installing the camera.
1.
Select a suitable place on the ceiling of the room where you would like to
mount the camera.
2.
Connect the video cable (recommended cable type: RG58) to the BNC
video out (1) of the camera and to the following connected video unit. The
maximum cable length should not exceed 200 m.
3.
Connect a 12V DC power supply to the power input of the camera (2).
4.
Hold the camera at the location where you want to mount it. Check the
orientation and angle of the camera.
5.
Remove the plastic dome from the housing by carefully unscrewing it
counter-clockwise.
6.
Change the orientation of the camera module (7) if necessary by loosening
the fixing screws (6), modifying the inclination and direction of the camera
module, and then tightening the fixing screws.
7.
Select the desired image framing at the lens by setting the zoom (5).
Optimise the sharpness by adjusting the focus (4) at the lens.
22
Werbung
Inhaltsverzeichnis
