Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 18
INSTRUCTION MANUAL
Before use, check that all couplings and covers
are properly sealed. Otherwise, the spray may
leak out from the couplings and covers, which
can cause a health hazard.
Beware of liquid spurting out if removing filler
cap immediately after use. Discharge pressure
from the tank using the trigger on the spray
boom before removing the cap, or open the
cap carefully.
Not suitable for spray-painting.
USE
Charge battery before use by connecting
charger supplied to mains electricity, and
connecting wire to charging socket (6).
Indicator light on charger will be red while
charging and green when charging is complete
(takes approx. 8 hours). Remove charger from
mains socket after charging.
Unscrew the tank cap (3) (leave the filter
under the cap), and pour the spray for use into
the tank (2). Replace cap.
Do not use sprayer when empty! This can
damage the membrane.
Fit nozzle required (1) to end of spray boom.
Switch on pump unit (5) on on/off button (7).
Adjust the shoulder straps to a suitable length
and put the tank on your back.
Direct spray boom to area to be sprayed and
press trigger (9) to spray.
ENGLISH
Before using chemicals, test using clean water
to ensure there are no leaks and that the
atomiser in the nozzle works correctly.
Always stand upwind when spraying to prevent
chemicals being sprayed onto you.
Switch off pump unit after use.
Recharge when spray pressure drops or if
pump unit emits a knocking noise.

Cleaning and storage

Empty the tank after use. Always dispose of
unused spray in accordance with local rules
and regulations!
Clean the tank and the tank cap thoroughly
inside and out after use. Read the instructions
for the spray for information on the type of
cleaning required. Do not use steel brushes,
scouring pads or strong or acidic cleaning
agents.
The pump unit and spray boom can be cleaned
internally by pouring some clean water or
detergent into the tank and spraying using the
spray boom as described above under Use.
If the sprayer has been used for a particularly
dangerous spray or for agents that might
produce a chemical reaction with other sprays,
it must always be taken apart and each section
must be cleaned thoroughly.
From time to time lubricate the pump handle
and nozzle with lubricant.
16

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis