Werbung
c) Removing and inserting the accumulator out of/into the
cordless screwdriver/vacuum cleaner
For removing the accumulator, press the two
lateral pushbuttons for unlocking it (7 or 13) (A).
Then, the accumulator can be pulled out
downwards (B).
For inserting the accumulator it is to position
with its correct orientation at the bottom of the
cordless screwdriver up to the point at which it
engages.
Repeat these steps for the vacuum cleaner.
d) Inserting/removing the tool into/out of the drill chuck
For safety reasons, first the turn-over switch (4) is to be set to its central posi-
tion to block the on/off switch (7).
Open the drill chuck by holding the internal ring
(F) with one of your hands and turning the outer
ring (E) with your other hand anticlockwise (AC,
seen from front to the drill chuck).
Insert the desired tool (a drill in the figure) into
the drill chuck.
Tighten the drill chuck by holding the internal
ring (F) with one of your hands and turning the
outer ring (E) with your other hand clockwise (D,
seen from front to the drill chuck).
To ensure that the tool (e.g. a
bore bit or a drill) is fixed in the drill chuck, it should be positioned at least 1cm
deep in the drill chuck (bore bits or small drills). Large drills are to be inserted
completely.
Proceed as follows to remove the tool: Open the drill chuck by holding the internal ring (F) with
one of your hands and turning the outer ring (E) with your other hand anticlockwise.
36
A
B
Figure 4
C
E
D
F
Figure 5
b) Eléments de commande de l'aspirateur
8
9
15
Figure 3
8
Réservoir de déchets
9
Séparateur d'eau
10 Filtre
11 Interrupteur Marche/Arrêt
12 Accumulateur
13 Bouton-poussoir pour le déverrouillage de l'accumulateur
14 Bouton-poussoir pour le déverrouillage du réservoir de déchets
15 Ligne de marquage pour le niveau de liquide maximum
10
11
14
13
12
57
Werbung
Kapitel
Fehlerbehebung
