Behringer MINIMIX MIX800 Kurzanleitung Seite 5

8
MINIMIX MIX800
MINIMIX MIX800 Controls
(3) (5)
(1) (2) (4)
(12) (13) (14)
(6) (8) (10) (11)
(7) (9)
(15)
9
Quick Start Guide
Step 2: Controls
MIC INPUT 1/2. 1 or 2 microphones
(EN) (1)
can be connected using these
1/4" jacks.
MIC LEVEL 1/2. The MIC LEVEL
(2)
control adjusts the level of the
microphone signal.
CLIP. When the Clip LED lights
(3)
up, distortion may occur in the
microphone input of the MIX800.
EQ LOW. The EQ LOW control
(4)
allows you to raise or lower the
low-frequency content of the
microphone signal.
EQ HIGH. With the EQ HIGH
(5)
control, you can raise or lower the
high-frequency content of the
microphone signal.
ECHO/REVERB. The MIX800
(6)
allows you to add an effect to the
microphone signal. When the
ECHO/REVERB button is pressed in,
you can add REVERB to the signal.
When the button is pressed out,
the ECHO effect is active.
FX LEVEL. The FX LEVEL control
(7)
determines the amount of effect
that is added to the master signal.
IN/OUT. Press the IN/OUT button to
(8)
activate the Voice Canceller in the
signal path. This filter circuit allows
you to remove the vocals almost
completely from a recording.
OUTPUT LEVEL. Set the volume
(9)
of the output signal with the
OUTPUT LEVEL control.
LED DISPLAY. The LED display
(10)
is for monitoring the input level.
It comprises 6 LEDs. When the Clip
LED lights up, distortion may occur
in the MIX800 output. Reduce
the output level with the OUTPUT
LEVEL control (9).
� SWITCH. The � switch turns
(11)
your MINIMIX MIX800 on and off.
Use the 9 V jack to connect the
(12)
power supply delivered with
the unit.
These connectors are the
(13)
unbalanced cinch outputs of
the MIX800.
These connectors are the
(14)
unbalanced cinch inputs of
the MIX800.
SERIAL NUMBER.
(15)
Check Out behringer.com for
Full Manual