Putting Into Operation - Kress 800 FDF Bedienungsanleitung

800 FDF - Titel.book Seite 12 Dienstag, 28. März 2006 1:51 13
English
12
12 Lock nut for index stop
13 Stop screw for index stop
14 Scale for height adjustment
15 Ejector adapter
16 On/Off switch
17 Cutting depth thumbwheel
18 Depth stop adjustment
19 Adjusting screw for depth stop adjustment
20 Lock nut for depth stop adjustment
21 Locking screw for angle adjustment
22 Angle scale
23 Spindle lock button
24 Dust collector
25 Adapter
26 Base plate
27 Screws (4x)
28 Cover
29 Two-pin spanner
30 Clamping nut
31 Routing blade
32 Supporting flange
Accessories illustrated or described are not always
included as standard delivery items.
Mounting the Auxiliary Handle and
6
the Mains Cable Module
Before any work on the machine itself, pull the
mains plug!
Connect the mains cable module 1 to the handle. The
plug must latch.
Use the mains cable module provided only for
Kress Electro-Tools. Do not attempt to operate
other machines with the module.
Only use original Kress mains cable modules and
at least flexible rubber tube (code designation
H05 RR-F).
7

Putting into Operation

Check before putting into operation that the mains
voltage agrees with the voltage specified on the
nameplate of the machine.
Switching On/Off
Push the On/Off switch 16 forward to start the
machine.
Pressing on the extended front edge of the On/Off
switch 16 switches the machine off.
Slip Protection
The two slip protectors 9 prevent the machine from
slipping sideward while routing biscuit grooves.
When routing longitudinal grooves while guiding the
machine sideward, the slip protectors 9 must be set
inward by turning them.
Protective Guard for Routing Blade
As a protection measure, the protective guard for the
routing blade 8 must always be mounted (exception:
vertical joint connection).
Push the protective guard 8 from below onto the
stop 6 and allow it to engage.
Choice of Biscuit Size
Always use the largest possible biscuit size for an
optimal connection. For workpiece thicknesses above
25 mm, 2 biscuits should be set above each other.
Workpiece Biscuit size No. Dimension
thickness
8 - 12 mm 0
12 - 15 mm 10
> 15 mm 20
Routing-depth Adjustment
The routing depth is adjusted with the thumbwheel 17.
The thumbwheel must latch in the respective position.
The corresponding values are preset for the most
common biscuit connections:
Biscuit Setting
Nr. 0 0
Nr. 10 10
Nr. 20 20
Simplex S
Duplex D
Maximum max.
For special applications, the routing depth can be var-
iably adjusted from 0 – 19.0 mm:
Set the thumbwheel to the "max." position.
Push the machine forward until the routing blade has
reached the desired routing depth.
Set the depth stop adjustment 18 to this measure by
loosening the lock nut 20 and turning the adjustment
screw 19 (1 revolution = 0.7 mm). Tighten the lock nut
again.
800 FDF
47 x 15 x 4 mm
53 x 19 x 4 mm
56 x 23 x 4 mm
Routing depth
8,0 mm
10.0 mm
12.3 mm
13.0 mm
14.7 mm
19.0 mm