Controls; Front View; Rear Panel - Onkyo SKW-208 Bedienungsanleitung

Controls

FRONT VIEW

a
a
STANDBY/ON indicator
Red: Subwoofer in standby mode
Blue: Subwoofer on
The Auto Standby function will automatically set
the SKW-208 to Standby mode when there is no
input signal, or when the input signal is below a cer-
tain level.
Note:
If the Auto Standby function sets the SKW-208 to
Standby mode even when an input signal is present, the
input signal level is too low. In this case, increase the
subwoofer output level on the amplifier or AV receiver
connected to the SKW-208.
4
En-

REAR PANEL

2 3
5
To AC outlet
b
POWER switch
Press this switch to the ON position to turn on the
power. Press it to the OFF position to turn off the
power.
c
FREQUENCY knob
Use this knob to select the high-frequency range at
which to cut off the signal to the subwoofer.
You can select any frequency between 50 Hz and
200 Hz, depending on the characteristics of the
speaker system.
d
PHASE switch
Use this switch to reverse the phase of the
SKW-208. Normally, set the switch to the "NOR"
position. Depending on the connected speakers or
the installation environment of the SKW-208 how-
ever, the "REV" position may result in better sound.
Select the switch position that produces a louder
bass sound.
e
OUTPUT LEVEL knob
Use this knob to adjust the volume of the sub-
woofer.
f
LINE INPUT jack
Connect this jack to the SUBWOOFER PREOUT
jacks on the amplifier etc.
4
6