Herunterladen Diese Seite drucken
Uponor T-24 Kurzanleitung

Uponor T-24 Kurzanleitung

Up raumfühler 230 v, verdrahtet

Werbung

Quick Guide
Uponor Thermostat Flush T-24 230 V, Wired
Kurzanleitung
Uponor UP Raumfühler T-24 230 V, Verdrahtet
!
Safety instructions
This thermostat may only be opened by a qualifi ed
electrician and installed in accordance with the wiring
diagram in these instructions.
After installation, the installer must teach the operator
or user the function and operation of the thermostat.
These instructions must be kept in a freely accessible
place.
!
Sicherheitsvorschriften
Dieser Thermostat darf nur von einer Elektro-Fachkraft
geöffnet und installiert werden. Die Installation muss
in Übereinstimmung mit dieser Anleitung und dem
Elektro-Schaltplan erfolgen.
Nach der Installation ist der Betreiber in die Funktion
und Bedienung der Regelung einzuweisen. Die
Bedienungsanleitung muss an frei zugänglicher Stelle
aufbewahrt werden.
Technical data
Operating voltage
Switching capacity
Control range
Switching difference
Temperature changing
Protection
Ambient relative humidity
(RH)
Dimensions (W × H × D)
Technische Daten
Betriebsspannung
Schaltvermögen
Regelbereich
Schaltdifferenz
Temperaturänderungs-
geschwindigkeit
Schutzart
Maximal Luftfeuchtigkeit
(RH)
Maße (B × H × T)
250 V ~, 50 Hz
10(4) A
+5 °C – +30 °C
~ 0.5 °C
≤ 4 °C/h
IP30, class II
95 %,
non-condensing
81.0 × 85.0 × 44.5 mm
250 V ~, 50 Hz
10(4) A
+5 °C – +30 °C
~ 0.5 °C
≤ 4 °C/h
IP30, Klasse II
95 %,
nicht kondensierend
81.0 × 85.0 × 44.5 mm
11 | 2011

Werbung

loading

Inhaltszusammenfassung für Uponor T-24

  • Seite 1 Quick Guide Uponor Thermostat Flush T-24 230 V, Wired Kurzanleitung Uponor UP Raumfühler T-24 230 V, Verdrahtet Safety instructions Technical data This thermostat may only be opened by a qualifi ed Operating voltage 250 V ~, 50 Hz electrician and installed in accordance with the wiring diagram in these instructions.
  • Seite 2 Min. +5 °C Use • Verwendung ~ 20 °C Uponor Corporation www.uponor.com Uponor reserves the right to make changes, without prior notifi cation, to the specifi cation of incorporated components in line with its policy of continuous improvement and development.