Operation; Specifications - ring WorkshopPro Hands Free REIL2750 Anleitung

EURO inspec lamp instructions 2750
!
This LED Inspection Lamp must be charged for at least 12 hours before
first use to maximise battery life.
To Charge
Mains Charging
1 Plug the charging adaptor into the
220/240v AC mains socket
2 Connect the lead from the
charging adaptor to the charging
point on the lamp
3 Switch on mains power
Typical charging time
approximately 4hrs
Red charging LED is displayed during
charging process
Green LED is displayed once
fully charged
4 When fully charged turn off the AC
Mains power and disconnect the
charging lead from the lamp
12v Charging
1 Connect the DC plug on the 12v
charging lead into a 12v DC socket.
i.e.the vehicle's cigarette lighter
socket
2 Switch on mains power
Typical charging time
approximately 4hrs
Red charging LED is displayed during
charging process
Green LED is displayed once fully
charged
3 When fully charged disconnect the
charging lead from the DC power
supply, following this disconnect
from the lamp

Specifications

Light output: 750 lux (0.5m)
Battery: 7.2v NiMH 850mAH
Mains adapter: Input 230v - 50Hz
Output 12v - 500mA
!
Never stare directly at the LEDs.
27/9/07
REIL2750
Hands Free High Power LED Inspection Lamp

Operation

1 Point the lens towards the direction
to which you require light
2 Press the on/off button to switch
on lamp
3 Press the on/off button to switch
off lamp
2 Rotate The hook/stand mechanism to desired angle
(45˚, 90˚, 135˚ 180˚)
Angle
45˚
90˚
135˚
180˚
3 To put the hook/stand
mechanism away rotate
back to position 1
and release
5:26 pm Page 2
Multipositioning
1 Pull down hook/stand
mechanism to position 1
Standing position
2
(PANTONE 293 C plate)
Hanging position