Conrad Passat Gebrauchshinweise Seite 25

How to operate your hand vacuum
1 Hold the hand vacuum firmly with your hand on the handle
2 Push the On/Off Power Switch to"On" position
3 Start vacuuming
Caution :
The hand Vacuum is a very powerful unit.Make sure that you hold it firmly, otherwise it can slip out
of your hand and cause injury.
Installation of the flat roller brush (Q)
1. assemble the 3 tubes to form a long handle
NOTE: You can adjust the length of the handle by assembly 1, 2 or 3 tubes (L).
2. attach the brush to the handle
3. then connect the handle to the vacuum cleaner using the long tube (F)
Helpful hint
: as with a traditional vacuum cleaner, lower the brush lever to clean flat surfaces (parquet, tiles,
linoleum, etc.). For all fabric surfaces (carpets and rugs), raise the lever to "brush" the fabric.
Using the cleaner in reverse mode
NOTE: your reversible vacuum cleaner is delivered in "normal vacuum" mode.
1. Unscrew the (flat) lid of the cleaner (fig. 1) and screw in the special "reverse" lid (R), (fig. 2).
2. insert the short tube (P) as indicated below, removing the second flat end.
3. Insert the end (4) of your choice onto the short tube (P).
4. Firmly hold the cleaner and press the on/off button.
Warning:
this manual vacuum cleaner has strong suction power. Hold the device firmly, so that it does not slip
out of your hands and cannot you bang in to you.
Changing & cleaning the dust cup filter
Warning
: Always unplug from electrical outlet before opening the dust Cup (container) (A).
1 To open the dust Cup (container) (A), push button (E) and pull out the Dust Cup (container) (A), (fig.1).
2 Pull out the dust Cup Filter (H), (fig.2).
3 Empty the dust from the dust Cup Filter (H)
4 Rinse the dust Cup Filter (H) in cold water, and then wait until it dries up before replacing it into the Dust
Cup (container)(A).
5 Place the dust Cup Filter (H) carefully into the dust Cup (container) (A).
6 Attach the dust Cup (container) (A) to the Hand Vacuum.
Caution :
The suction hole (A) must be open, free of any obstructions at all times. Otherwise, the motor will
overheat and could get damaged.
fig. 1 fig. 2