Werbung
Verfügbare Sprachen
Verfügbare Sprachen
IMPORTANT
Use of controls or adjustments or performance of procedures other than those specified herein may
result in hazardous radiation exposure.
CD player function:
1.
SOURCE BUTTON
Press the power switch to turn the unit on. To switch the POWER off press the POWER switch
again.
2.
EJECT BUTTON
Press to load or eject disk. Each press will open or close the disk tray.
NOTE: Disc holder will not open unless stop or pause button has been pushed first.
3.
TIME BUTTON
Use this knob to choose the time mode: elapsed time, remaining time or total remaining time.
4.
SINGLE BUTTON
Press this button to switch between the SINGLE and CONTINUOUS play mode. The selected
mode is indicated on the LCD. In SINGLE mode, after each track, the unit stops the reading. In
CONTINUOUS mode, the unit reads all tracks and stops.
5.
REPEAT BUTTON
Use this button to repeat one track or all the track of the CD.
6.
PROG BUTTON
In STOP mode, you can program several tracks ( 20 tracks max ) :
-
Press the STOP button to enter in the stop mode
Press the PROG button to enter in the program mode
-
Use the skip track buttons to choose the track you want to listen then press the PROG button to
-
enter your choice
Use one more time the skip track buttons to choose the track you want to listen then press the
-
PROG button to enter your choice
Repeat the operation to select all the track you want to listen
-
Press the PLAY/PAUSE button to start the playback
-
7.
FOLDER BUTTON
Allows you to navigate through folders similarly in either USB or CD mode.
8.
SEARCH
BUTTON
You may forward and backward to navigation through one track.
9.
TRACK SEARCH
To select the previous track and select the next track.
10. DSP/BRAKE
In play mode, push the brake button at first, and then push play/pause button, the operation
changes is slowness from play to pause, push play/pause button again to cancel this feature.
11. DSP/REVERSE
Push the reverse button to play your track in reverse, push the reverse button again to cancel
this feature.
12. TRACK SELECT BUTTONS
Press the button to switch the function of jog dial to SEARCH and PITCH BEND and
SCRATCH mode, when the indicator LED is off, dial the jog for pitch bend function. If the jog is
unmoved for 8 seconds, the indicator is off and the jog is for pitch bend function. When the
indicator LED is light, rotate the jog wheel to enter the scratch mode, while the indicator LED is
flashing, dial the jog for quick search forward and backward.
© Copyright LOTRONIC 2010
AND
BUTTON
3
Werbung
