Renkforce 1296292 Bedienungsanleitung Seite 3

G Operating Instructions
Wireless chime
Item no. 1296292
Intended use
The product consists of a radio chime with integrated speakers and a radio doorbell button with
sensor surface. If the sensor surface is touched on the wireless doorbell button, it wirelessly ac-
tivates a tone on the wireless chime (48 different audio signals / ring tones to choose from). The
playback volume of the audio signal can be adjusted in several steps.
The wireless chime can be powered either by 3 batteries of type AAA/Micro or by a power supply
cord (each available as accessory).
The wireless chime is powered by a 12 V battery (type 23A; included).
The wireless bell push is protected according to IP44 and can be used in protected outdoor areas
(e.g., under eaves). The wireless chime may be used only in dry, enclosed areas indoors.
Always observe the safety instructions and all other information included in these operating in-
structions.
This product complies with the applicable national and European requirements. All names of com-
panies and products are the trademarks of the respective owners. All rights reserved.
Contents
• Wireless chime
• Wireless doorbell button with battery (type 23A) and wall bracket
• Operating instructions
Explanation of the symbols
This symbol indicates specific risks associated with handling, function and use.
The "arrow" symbol indicates special tips and operating information.
Safety Instructions
The warranty will be void in the event of damage caused by failure to observe these
safety instructions. We do not assume any liability for any resulting damage!
We shall not accept liability for damage to property or personal injury caused by in-
correct handling or non-compliance with the safety instructions. In such cases, the
warranty will be null and void.
• Unauthorised conversion and/or modification of the product is not allowed for safety
and approval reasons (CE).
• This product is not a toy, and should be kept out of the reach of children. Small parts
of the product or the batteries could be swallowed.
• Do not use this product in hospitals or medical institutions. Although the product
emits only relatively weak radio signals, these may lead to the malfunction of life-
support systems. The same may also apply to other areas.
• The product must not be exposed to extreme temperatures, strong vibrations or
heavy mechanical stress.
• The outdoor sensor is suitable for use in sheltered outdoor areas (e.g., under a roof
overhand). It must not be used in or under water, this will destroy it.
The camera is suitable for indoor use only; it must not get damp or wet.
• Do not operate the device in environments where there are high levels of dust, flam-
mable gases, vapours or solvents. There is a danger of fire and explosion!
• If the product appears damaged, do not use it. Instead have it checked / repaired by
a qualified technician or dispose of it in an environmentally friendly manner.
• Do not leave packaging material carelessly lying around, since it could become a
dangerous plaything for children.
Notes on Batteries and Rechargeable Batteries
• Batteries/rechargeable batteries must be kept out of the reach of children. Do not leave the
batteries/accumulators lying around. There is a danger that children or pets may swallow them,
danger to life! If they are swallowed, consult a doctor immediately.
• Make sure that rechargeable batteries are not opened, short-circuited or thrown into a fire, as
there is a risk of explosion.
• Check that the polarity is correct when inserting the batteries/rechargeable batteries (pay at-
tention to plus/+ and minus/-).
• Chemical liquid may leak out of spent or overly aged batteries, which may damage the device.
Leaking or damaged batteries/rechargeable batteries may cause acid burns when coming into
contact with skin, therefore use suitable protective gloves.
• Do not mix batteries with rechargeable batteries.
• Do not mix batteries/rechargeable batteries with different charge levels (e.g., full and half-full
batteries/rechargeable batteries).
• Replace the entire set of batteries and never individual cells.
• The wireless chime is intended for use with a 12 V battery, type 23A.
• The wireless chime is intended for use with 3 AAA/Micro batteries (alternatively, an external
power supply can be used, not included, can be ordered separately).
The wireless chime can also be used with 3 NiMH batteries AAA/Micro, but for a short-
er period of time only, due to the lower voltage (NiMH battery = 1.2V, AAA battery =
1.5V).
For this reason, we recommend that you put in the wireless chime only high-quality
alkaline batteries, not rechargeable batteries, in order to ensure a long and safe opera-
tion.
Inserting/replacing the batteries
a) Wireless chime
• Open the battery compartment on the back of the wireless chime. Insert two "Micro/AAA" bat-
teries, with the correct polarity (observe +/Plus and -/Minus).
• Close the battery compartment again.
The batteries need to be changed if the audio signal is barely audible or cannot be
heard at all anymore.
Dispose of the batteries with respect to environmental protection; see chapter "Dis-
posal".
b) Wireless doorbell button
• First, detach the U-shaped wall mounts from the back of the wireless doorbell button. These are
only clipped in place.
• Open the case of the wireless doorbell button, press the lock button at the bottom and carefully
open the front lid at the top of the wireless chime. Then, finally you can pull off the front lid. Do
not use force.
On the circuit board, turn on the wires that aren't straight, this results in decreasing the
range, or the wireless chime no longer responding to the radio doorbell button.
• During the first use, the 12 V battery (type 23A) is already inserted in the wireless doorbell
button. A small protective strip between the battery and the contacts prevents premature dis-
charge of the battery. Peel off the protective strip.
If a battery change is required (e.g., if the operating range becomes reduced, or the
chime no longer responds to the radio doorbell button), replace the old battery with a
new battery of the same type.
Please pay attention to the correct polarity (observe plus/+ and minus/-) when inserting
the battery. See the label on the board.
Dispose of batteries with respect to environmental protection; see chapter "disposal".
• Place the front lid of the button back diagonally onto the device and lift it so that it snaps into
place.